Page 1 of 1

Herschel PULSAR

Número de pieza Potencia

nominal

Dimensiones Peso Zona Calentada m2

IRPULSAR-1800W 1800W 80 x 38 cm 28 kg 12 - 20

IRPULSAR-2400B 2400W 80 x 38 cm 28 kg 12 - 20

Elemento calefactor Elementos

calefactores

cerámicos

Tensión 230V 50/60Hz

Cuerpo Acero esmaltado

blanco o negro

Tiempo de

calentamiento

<10 minutos

Longitud de onda útil 3 - 10μm

Grado IP IP20

Cable 1.5m

Certificados

Garantía 1 años

The Pulsar is our zero light designer space heater which can be suspended from high ceilings. The Pulsar will directly warm people below the heater and so

can be used in applications such as reception areas, restaurants and public areas. When used in smaller enclosed spaces such as hallways Pulsar will heat

the zone and the room itself.

Pulsar is made in Europe from high quality materials and is completely maintenance free. The heater takes around 10 minutes to warm up and should be

used in conjunction with Herschel IQ controls. The black Pulsar is higher power and more effective for space/zone heating applications. The white Pulsar is

relatively low power and more suited to heating smaller rooms or as a supplementary heater to existing systems.

Emitting the gentle, cosy feeling of radiant heat, Pulsar provides a contemporary and effective electric heating solution for high ceiling spaces.

The White Pulsar is 1800W and will heat an enclosed indoor area of 8 - 15m2 from a height of up to 2.5m . The Black Pulsar is 2400W and will heat enclosed

indoor areas of 12-20m2 from a height of up to 2.8m. These areas are a guideline only and will be impacted by airflow and ambient temperatures.

Dependent upon the property age/type, insulation levels and levels of airflow present, the number of heaters required and running times will vary. For larger

domestic or commercial projects we recommend Herschel carry out a survey or detailed desktop assessment. Always refer to the installation instructions.

In areas with air movement/wind the directional Far Infrared spread may reduce by 1/3 to 1/2. In these areas we recommend mounting at the lowest height

and proportionally increasing the number of heaters.

The Herschel Pulsar rises to high temperatures in use and the unit must not be touched when power is applied. Do not place the emitting surface closer

than 1m to any object or wall and sides and top no closer than 600mm from any surface or wall. After switch off the elements remain hot for a considerable

time and the unit should not be touched for a minimum of 30 minutes. NEVER use the heater to ignite materials. Ensure supply voltage does not exceed 245

volts. It is not approved for exterior use.

The Herschel Pulsar is guaranteed against failure due to faulty materials or workmanship for 12 months from the date of purchase. In the unlikely event of

failure of the unit within this time, the unit must be returned to Herschel for repair or replacement and excludes any cost of installation or consequential

losses. The guarantee is invalid if the correct installation instructions have not been adhered to.

Modelos disponibles

IMPORTANTE

Detalles técnicos