Page 1 of 2

01

1

2

3

B

Steering Dual Rate

Lever (D/R)

Steering Trim

Lerer (CH1)

Connects to the steering servo

Motor connector

Battery connector

Power switch

CONNECTION

MT-202

MT-202T

227g

Operating

RF

6.0~8.4V(Ni-cd)

Antenna (Built in)

6.0~7.4V(Li-poly 2s)

0.26oz (7.4g) 8

MT-202RE

Page 2 of 2

02

MT-202T:

1.CH1(Steering) Trim:

Steering neutral adjustments can be made by moving the steering trim lever to the left or right.

When you install a servo, always check to be sure the servo is at its neutral position. Adjust the servo horn position

and linkage so both are parallel. Be sure the steering trim on the transmitter is at the neutral position.

2.CH1(Steering Dual-Rate)D/R:

Use this function to adjust the steering travel of your model. If the model understeers while cornering, add steering by

rotating the CW side of the D/R knob. When the model oversteers, take away steering by rotating the C.CW side of the

D/R knob.

3.CH1(Steering)Reverse:

If the servo operate in the opposite direction,moving the reverse lever

for the servo reversing.

4.Low Battery Indicator:

If the transmitter battery voltage drops below 4.2V the LED will be flashed.

MT-202RE:Receiver+ESC for 1/18 Car

1.CH1(Steering)Output:Connect the servo for steering operation.

2.Battery connector: Connects to the battery.Red is plus+,Black is minus-. For Ni-cd battery 5~7cells(6.0~8.4V) or

Lithium-Poly battery 2S(7.4V)

3.Motor connector:Connect to the motor.

4.CH2(Throttle) Operation:Forward 、reverse and brake are all linear.

When switched to reverse operation just returning the throttle trigger from the brake position to the neutral position.

5.Low-battery&Heat protection:When the battery voltage drops below 5.5V or the FET are over heat,the motor will shut

off and the LED will be rapid flash.

MT-202T&MT-202RE Bind:

Binding Process

1.Turn the transmitter power on while pressing the bind sw.

2.The transmitter Red LED will flashing for 20 seconds.

3.Plug the battery into the MR-202, then turn on the power while the transmitter LED is flashing.

4.When the LED on the receiver unit is steady light ,binding is complete.

5.When the binding procedure is successful, the LED on the receiver will stay solid red when both the transmitter and

receiver are turned on.

MT-202T LED Display

LED ON:Power on

LED Rapid Flash:Battery low

LED Slow Flash:Bind mode

MT-202RE LED Display

LED OFF:Indicates that the power is off or no signal reception

LED ON:Receiving signals

LED Rapid Flash:Battery low or heat protector is detected.